EDM 07529 Instrucciones De Uso página 19

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
07629
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
USE OF THE COMBINATION ACCESSORY
Be careful not to cut your hand with the blade when placing or
removing the comb attachment.
Make sure the trimmer is turned off.
1. Mount the comb attachment on the main body until it clicks.
Cutting height (estimate)
- Comb from 1 mm to 10 mm - for beard
- Comb from 11 mm to 20 mm - for hair
The trimming height of the body hair comb attachment cannot be
adjusted.
This comb accessory is trimmed to a length of about 1.5mm
2. Turn the dial and adjust the cutting height indication mark to the
desired height.
CUTTING BEARD
Do not use with applied shaving foam or when
the beard is wet. A wet beard can
adhere to the skin or group together, making it difficult to cut.
Beard length adjustment
Make sure the trimmer is turned off.
1. Place the beard comb attachment on the main body.
2. Set the trim height.
3. Holding the trimmer with the power switch facing up, trim by
bringing the blade into contact with the skin and moving the
trimmer against the flow of the beard.
Haircuts can accumulate inside the accessory when a large volume
of beard is cut, so discard it after each use.