TMC Reef EASI-Dose Manual Del Usuario página 4

INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
- Always isolate from the mains electricity before installing or carrying out any
maintenance to the EASI-Dose dosing system.
- Power to the EASI-Dose Dosing system must be supplied through a Residual Current
Device (RCD) with a rated residual operating current not exceeding 30mA.
- Pump rating: 220-240V, 50Hz unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it
has been dropped or damaged in any way.
- This unit is designed to be used indoors and is not suitable for any outdoor applications.
- Ensure the EASI-Dose Dosing System is safely positioned before operating.
Caution: The EASI-Dose Dosing System is not waterproof and therefore must not be
mounted above the aquarium or in any position where it may accidentally fall into water or be
splashed by water.
- Always leave a drip-loop in the cables to prevent water running down the cable and
reaching the power source (see below).
- Dispose of this unit responsibly. Check with your local authority for disposal
information.
- Please Note: It is advisable to consider the quantity and
concentration of the additive in your dosing container in order
to reduce any risks of overdosing your tank. Thought should be
given to the unlikely event that the dosing system is set up
incorrectly or should fail and the total amount of product in
the dosing container could be dosed into your tank. It is advised
not to exceed a volume / concentration that would lead to your
water parameters being a ected to a degree that could result in
harm to the tank inhabitants. Please refer to the dosing instructions
of the additive to be added for maximum recommended dose rates.
It is also recommended to undertake daily checks on your
equipment. The TMC Easi Dose containers are graduated in
order to keep an eye on daily usage levels.
Drip Loop
1