1
Screw the lower stand bar into the base
and rotate clockwise until secure.
3
Unscrew the top stand connector from the
upper and middle stand bars.
5
Unscrew the stand connector then insert
the middle stand bar into the lower stand
bar, aligning the A and B tabs, as shown
above.
K8000seriesIM1261_V08.indd 23
K8000seriesIM1261_V08.indd 23
ASSEMBLY
2
Slide the amp down over the lower stand
bar.
4
Lower the top stand connector and rotate
clockwise to tighten.
6
B
A
Lower the stand connector and rotate
clockwise to secure.
23
30/06/2011 10:39
30/06/2011 10:39