Tripp-Lite VR1208R Manual Del Propietário

Important Safety Instructions
• Install your voltage regulator indoors, away from excess moisture
and heat, direct sunlight, and dust and other conductive
contaminants.
• For best performance, keep the indoor temperature between 0º
C and 40º C (between 32º F and 104º F ).
• Leave adequate space around all sides of the voltage regulator
for proper ventilation.
• Connect your voltage regulator directly to a three-wire, grounded
AC power outlet. Do not remove or modify the ground pin of
the voltage regulator's plug. Do not use adapters that would
eliminate the voltage regulator's connection to ground.
• Do not use extension cords between the voltage regulator and
the AC outlet. If necessary, a Tripp Lite Surge Suppressor may be
used between the voltage regulator and the AC outlet.
• Use of this equipment in life support applications where failure of
this equipment can reasonably be expected to cause the failure
of the life support equipment or to significantly affect its safety or
effectiveness is not recommended. Do not use this equipment in
the presence of a flammable anesthetic mixture with air, oxygen
or nitrous oxide.
Installation
Connect your voltage regulator to an electrical outlet.
1
Plug your computer and electronics into your voltage regulator's
2
outlets. NOTE: Four outlets feature Automatic Voltage
Regulation (AVR) only and four outlets feature surge
suppression only. Connect your computer and electronics
accordingly.
Turn your voltage regulator's power switch on.
3
Fax/Modem Protection
NOTE: This connection is optional. Your voltage regulator will
work properly without this connection. Using telephone cords,
connect your wall jack to the voltage regulator jack marked "IN"
and your equipment to the voltage regulator jack marked "OUT".
Indicator Lights
BOOST: This yellow light will turn ON whenever your voltage
regulator is boosting low AC line voltage up to nominal
voltage levels.
POWER: This green light will turn ON whenever your voltage
regulator is receiving normal AC line voltage.
CUT: This red light will turn ON whenever your voltage
regulator is reducing high AC line voltage down to
nominal voltage levels.
201110138 93-2840 - New.indd 1
Owner's Manual
Voltage Regulator
Models: VR1208R (120V, 60Hz Input, Output) &
VR2008R (120V, 60Hz Input, Output)
Copyright © 2010 Tripp Lite. All rights reserved.
Warranty Information
TRIPP LITE warrants its products to be free from defects in materials and workmanship
for a period of two years from the date of initial purchase. TRIPP LITE's obligation
under this warranty is limited to repairing or replacing (at its sole option) any such
defective products. This warranty does not apply to equipment which has been
damaged by accident, negligence or misapplication or has been altered or modified in
any way. This warranty applies only to the original purchaser who must have properly
registered the product within 10 days of purchase.
EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of implied
warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the
purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT,
INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE
USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
Specifically, TRIPP LITE is not liable for any costs, such as lost profits or revenue,
loss of equipment, loss of use of equipment, loss of software, loss of data, costs of
substitutes, claims by third parties, or otherwise.
Warranty Registration
Visit www.tripplite.com/warranty today to register the warranty for your new Tripp Lite
product.You'll be automatically entered into a drawing for a chance to win a FREE
Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website
for details.
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite
product has been assigned a unique series number. The series number can be found on
the product nameplate label, along with all required approval markings and information.
When requesting compliance information for this product, always refer to the series
number. The series number should not be confused with the marking name or model
number of the product.
FCC Part 68 Notice (United States Only)
If your Modem/Fax Protection causes harm to the telephone network, the telephone
company may temporarily discontinue your service. If possible, they will notify you in
advance. If advance notice isn't practical, you will be notified as soon as possible. You
will be advised of your right to file a complaint with the FCC. Your telephone company
may make changes in its facilities, equipment, operations or procedures that could
affect the proper operation of your equipment. If it does, you will be given advance
notice to give you an opportunity to maintain uninterrupted service. If you experience
trouble with this equipment's Modem/Fax Protection, please visit www.tripplite.com/
support for repair/warranty information. The telephone company may ask you to
disconnect this equipment from the network until the problem has been corrected
or you are sure the equipment is not malfunctioning. There are no repairs that can
be made by the customer to the Modem/Fax Protection. This equipment may not be
used on coin service provided by the telephone company. Connection to party lines
is subject to state tariffs. (Contact your state public utility commission or corporation
commission for information.)
Tripp Lite follows a policy of continuous improvement. Product specifications are
subject to change without notice.
1111 W. 35th Street, Chicago, IL 60609 USA
www.tripplite.com/support
201110138 • 932840-EN
10/25/2011 3:03:21 PM