Maintenance And Care - INOX MARINA R52 Traducción De Instrucciones Originales

English

7 MAINTENANCE AND CARE

Before carrying out any maintenance
or cleaning work, pull off the sparkplug
connector!
Do not spray the unit with water. Water
which gets into the ignition system or the
carburertor may result in malfunctions.
Clean the unit with a cloth, hand brush, etc.
When the mower is tilted to the side,the
carburettor must be pointing upwards!
Expert inspection is required:
- if the lawn mower strikes an object
- if the motor stops suddenly
- if the blade is bent (do not align!)
- if the motor shaft is bent (do not align!)
- if the gears are damaged
- if the V-belt is defective
Changing the oil / air filter / spark plug
See operating manual supplied by the engine
manufacturer.
Drive gears
The gears are maintenance-free.
Replacing and sharpening the mowing
blade
At the end of the mowing season always
sharpen the mowing blade or, if required,
replace the mowing blade with a new one.
Always have the mowing blade sharpened
or replaced by a customer service centre
(measurement of imbalance).
Unbalanced blades will cause the
lawn mower to vibrate violently – risk
of accident!
en-8
Mulching cut (optional)
1) turn off the machine and ensure the blade
has stopped.
2) lift the back stone-guard and fit the plug
provided.
3) release the stone-guard.
Side discharge (optional)
1) fit the mulching plug as per point
2) lift the side stone-guard and position the
deflector.
3) release the side stone-guard.
Deck washing (optional)
When the machine has stopped and is
switched off:
- Connect the coupler (19) on the deck to the
water-supply tap.
Turn on the tap.
- Switch on the engine (the blade should be
spinning) and let it run for a few minutes.
- When the machine is clean, switch off the
engine. Turn off the tap and remove the hose
from the coupler.