NEC MultiPresenter Stick DS1-MP10RX1 Manual Del Usuario página 20

NETWORK INFORMATION
Display the information when this device is wirelessly connected to the network.
WIRELESS LAN SETTING
Configure the settings for wirelessly connecting this device to the network.
Item
PROFILE - SIMPLE ACCESS POINT
- SMART CONNECTION
- INFRASTRUCTURE
DHCP/ Set these when [INFRASTRUCTURE] is selected for
IP ADDRESS/ [PROFILE].
SUBNET MASK /
GATEWAY
DETAIL SETTINGS The configuration items are differed in each profile
option. Refer to the following table.
RECONNECT Attempt connecting to the network. Select this after
changing the configuration.
DETAIL SETTINGS (SIMPLE ACCESS POINT)
Item
SECURITY SETTING Select the security type (WPA2-PSK).
SSID Set the SSID.
CHANNEL Select a wireless channel.
Description
Set this device as a simple access point for con-
necting to a computer or a smart phone.
Easily connect to a computer or a smart phone
utilizing the application software, MultiPresenter,
installed on them.
Connect this device to an access point.
Description
- The default factory setting is [SMART
CONNECTION].
- If either [SIMPLE ACCESS POINT] or
[SMART CONNECTION] has been set
up, the IP address for this device is
"192.168.120.1" and the subnet mask
is "255.255.255.0".
Note: Number of device that can be simul-
taneously connected under SIMPLE ACCESS
POINT or SMART CONNECTION is up to
twelve units.
Recommendable number of device for si-
multaneous connection is up to eight units
for normal operation.
- The default factory setting is [DIS-
ABLED].
- WPA2-PSK consists of 8 to 63 alphanu-
meric characters.
- The default factory setting is produc-
tion serial number.
- Consists of 1 to 32 alphanumeric char-
acters.
- The default factory setting is "6".
ENG-10
Remarks
Remarks