Dock - Trek Lync Manuala Complementario

To remove the battery pack
1. Push and hold the latch (Figure 2) while
you slide the battery pack along the
down tube (Figure 3) about 5mm.
2. Lift the battery pack away from the dock
(Figure 4).
To install the battery pack
1. Make sure the battery pack and dock
are clean. If required, wipe the contacts
with a damp cloth, fingertip, or pencil
eraser.
2. Place the battery pack flat on the dock
in position for installation (Figure 3) so
that the hooks (Figure 5) are aligned for
engagement.
3. Slide the battery pack along the dock
until the latch locks the battery pack into
place.
You should hear a 'click' when the latch
Indicator light
Latch
Trek Lync Owner's Manual Supplement | Parts of the System
FIGURE 2
Battery pack
installed on dock
FIGURE 3
Battery pack in
position for removal
or installation
FIGURE 4
Lifting the battery
pack away from

dock

engages. The red indicator light on the
battery will illuminate for about three
seconds, and the front and rear lights will
flash momentarily.
Recycling
The battery will eventually lose strength.
When the charge no longer lasts as long as
it should, purchase a new battery pack from
your dealer. When you do, please recycle
the old battery pack. In the
U.S. go to
http://www.call2recycle.org/
Ask your dealer for the
location of a recycling centre.
Dock
The dock is located on the
down tube of the bike frame,
near the crankset (Figure
5). When the battery pack is
removed from the bike, use the dock cover
to protect the electrical contacts of the
dock (Figure 6).
If the battery pack (Figure 2) is on your bike,
the dock is underneath the battery pack.
Hooks
FIGURE 5
Dock on down tube
of frame
FIGURE 6
Dock cover protects
electrical contacts
33