Publicidad
Idiomas disponibles
Idiomas disponibles
To assemble the LED rotating beacon you need a standard base for
rotating beacons. The standard base for the "old" rotating beacon
without LED technology will also fit.
1. Screw the standard base tight at a suitable point on the roof of
the vehicle so that the rotating beacon is clearly visible from all
sides.
2. Open the clamp screw on the rotating beacon and slide the
standard base of the rotating beacon into the base.
3. Tighten the clamp screw.
The LED rotating beacon has 3 possible functions, which can be se-
lected by pressing the red button:
1. Unscrew the lamp glass and press the trigger switch to switch to
the next function.
2. The system has a memory function; the most recently set version
is retained.
Three functions are possible: Single flash: 125 times/min.
Trigger switch for three different functions.
Double flash: 250 times/min.
All-round flash: 120 times/min.
6
Publicidad
