Fleck 3200 ET Manual De Uso página 32

3 - PROGRAM LEVEL #2
LEVEL #2 - OPTION SETTINGS - SOFTENER
Setting up the valve during manufacturing of the softener requires access to the second level of
programming.
This level includes the functioning parameters of the softener related to actual system
configuration.
ENTERING LEVEL #2
A- Press the button
is used to set the inlet water hardness. Then press the button
B- The and
C- Passing to the next display, push the
Note: depending on the current programming, certain displays will not be viewed or set.
2.1 FLOW RATE (F
Not viewed in timeclock regeneration mode.
Press the button
flow rate of treated water. The unit of measure is the litre per minute.
Ex.: 8,6 l/min
2.2 DAYS SINCE THE LAST REGENERATION (
Press the button
of days recorded since the last regeneration. This display is used as an aid in the valve
maintenance and is not an option setting.
Ex.: 2 Tage
2.3 PRIOR SERVICE VOLUME USED (E):
Not viewed in timeclock regeneration mode.
Press the button
water used since the last regeneration. This display is used as an aid in the valve maintenance
and is not an option setting.
The unit of measure used depends on the display format chosen
Ex.: 58,6 m 3 (1)
(1) The unit of measure depends on the display format chosen.
All examples above are based on the cubic meter format (see point 2.12).
31
MANUFACTURER PROGRAMMING
for 5 seconds. The program arrow turns on and the first display viewed
set buttons are used to set the parameter values of different displays.
button.
r
):
.This display is identified by the letters "Fr". This first display is the current
.This parameter is identified by the letter "d". This display shows the number
. This display is identified by the letter "E". This display shows the amount of
for 5 seconds.
[Fr - - - 8.6]
d
):
[d - - - - - 2]
(1) .
[E - - - 58.6]
3200 ET & RM
E
N
G
L
I
S
H