Connections Terminals - jcm-tech ACTIVA Manual Del Usuario

Connections terminals

Disconnect the power before handling.
•Connect the three terminals to match the settings on the receiver unit installed
inside.
•To connect the ACTIVA antenna and the receiver unit located inside the facility, use
a 3-wire twisted sheathed cable.
In the case of using standard 4-strand cable, the correct connection is as follows:
Cable connection enlarged
For extreme cases of more than 200 metres distance, the cable
can be extended some metres further by placing a 1K resistance
between the "S" and "-" terminals, always depending on the inter-
ference that may arise in the installation itself.
+ Alimentación, 12 V
Supply voltage,
-
ground
S Coded signal
jcmtechnologies
6