Descargar Imprimir esta página

Blanco LINUS-S ND Información Tecnica Sobre Producto página 6

Ocultar thumbs Ver también para LINUS-S ND:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GB
Technical Product Information BLANCOLINUS-S ND / BLANCOLINUS ND
Parts list BLANCOLINUS-S ND
1 Lever
2 Coloured cap
Screw of the lever
3 Cartridge lock nut
4 Cartridge
5 Hose spray
6 Jet regulator
7 Spray hose
12 Seal spray hose
8 Angled pipe
21 Fitting
9 Set of seals angled pipe
10 Locking bolt angled pipe
11 Base
13 Mounting set
14 Assembly nut
15 Flexi-hose
16 Weight
17 Non-return valve and housing
18 Nonreturn head
19 T-Nipple
20 Seal flexi-hose
21 Fitting
22 Stabilising triangle
Technical Data
Applications
• Warm water tank low pressure
(open warm water heater)
Flow pressure
• Min.
• Max.
• Above 5 bar, a pressure reducer must be
installed.
The kitchen fitting is equipped with a flow rate
controller.
Temperature
• Max. (warm water inlet)
• Recommended (energy saving) 60° C
• Tap: warm-left / cold-right
4
1
Parts list BLANCOLINUS ND
Before installation and commissioning
Before the fitting is installed, the inlet pipes must
be thoroughly flushed so that no swarf, pieces of
hemp or other contaminants can enter the fitting.
Foreign bodies can enter the fitting through pipes
which have not been flushed, or the water system
0,5 Bar
in general, and damage the ceramic discs and
10 Bar
O-rings.
The installation of a water filter is recommended in
all cases.
Before installing the fitting, unscrew the perlator/
aerator and flush well.
Installation
70° C
Rinse all pipes well in order to eliminate any dirt
residue. Place the tap in the hole making sure the
washer is correctly positioned between the tap
and the surface. Block all the parts using the
special nut, gasket and washer. (13). Screw the
flow reducer (17) to the G 3/8" water supply pipe.
Connect the flexible pipe with the G 1/2" cap to
the fitting with flow reducer (17).
1 Lever
2 Coloured cap
Screw of the lever
3 Cartridge lock nut
4 Cartridge
6 Jet regulator
8 Spout
9 Set of seals spout
10 Holding screw spout
11 Base
13 Mounting set
15 Flexi-hose
17 Non-return valve and housing
18 Nonreturn head
22 Stabilising triangle
3

Publicidad

loading

Este manual también es adecuado para:

Linus nd