Using The Mixer - Soba HM22 Modo De Empleo

HM22 HAND-HELD MIXER
SETTING UP THE MIXER
Inserting and removing the blender
• Slide the cover plate on the hand mixer upwards.
• Push the blender into the opening and turn it anticlockwise.
• To remove the blender from the body, turn it clockwise.
• Close the cover plate.
Inserting and removing the mixing elements/dough hooks
• To insert the whisks and dough hooks push them into the appropriate openings
on the underside of the mixer.
• To remove them, press the eject button. Take care that the cover plate for the
blender mounting is always closed when using the appliance.

USING THE MIXER

BEFORE USING THE APPLIANCE FOR THE FIRST TIME, CLEAN THE BLENDER AND THE
MIXING ELEMENTS IN SOAPY WATER AND DRY THE PARTS WELL BEFORE MOUNTING
THEM (CF. "CLEANING" SECTION).
• Before switching on, hold the blender vertically in the ingredients. In this way you
can be sure that the ingredients will not splatter or run over.
• Plug the plug into the socket.
• Start up the blender and turn the speed control to the appropriate speed. The
speed may have to be varied according to the consistency of the mix.
• To use the highest speed, turn the speed control right up (motor is not running)
and press the impulse/turbo button.
• When you select a higher speed you automatically increase the power. If the mix
is heavy, increase the power by switching to a higher speed.
• The mixer should not be used continuously for more than 5 minutes at a time.
• The appliance can be used in a bowl, jug or casserole or even, with only one
mixing or needing element, in a mug. Hold the blender upright and move it gently
back and forwards while mixing the ingredients. When you switch off wait until
the blender or mixing elements have stopped turning before lifting them out of
the mix. Between work phases you can stand the hand mixer upright on the
rubber feet.
• Take care that the mixing elements/dough hooks do not touch the bottom of the
bowl.
4
INSTRUCTIONS