Prepare The Opening - Advantium ZSC1001 Instrucciones De Instalación

IMPORTANT:
Always maintain 36-3/4" minimum
height from the floor to the cutout in any single or
combined installation.

PREPARE THE OPENING

The Advantium 120 can be installed in
combination with other Built-In Appliances.
Always follow each product's Installation
Instructions to complete the installation.
Single Advantium 120 Installation:
Order a 27" or 30" wide single oven cabinet
or cut the opening in a wall to the dimensions
shown.
27" or 30"
17-1/2"
36-3/4"
Min.
• Allow the following clearances around the
cutout on the front surface of the cabinet: 1/4"
from the top for ZSC1001 models or 5/8" from
the top for PSB9100 models, 7/8" from the
side edges, and 1–1/8" from the bottom. (Note:
these refer to minimum clearances required for
installation and do not reflect actual product
dimensions.)
• Oven overlaps will conceal cut edges on all
sides of the opening.
When installed over a single oven or a
warming drawer, allow at least 2" between
the two openings. This separation will provide
clearance for bottom overlap of the Advantium
120 and the other appliance overlaps.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
Standard Installation Preparation
23-1/2"
25-1/4"
Construct
solid bottom
- Min. 3/8"
plywood
supported
on all four
sides. Must
be able to
support
weight of
oven and
contents.
PREPARE THE OPENING
Installation over a Warming Drawer:
27" or 30"
17-1/2"
36-3/4"
Min.
may be required. Check to be sure the oven
supports above the Warming Drawer location does not
obstruct the required interior depth and height. See
Warming Drawer installation instructions for details.
PREPARE THE OPENING
Installation over a Wall Oven:
27" or 30"
17-1/2"
45-1/4"
Min.
use the dimensions shown. The middle rail
separating the two openings may need to
5
(CONT.)
Construct
23-1/2" solid bottom
- Min. 3/8"
plywood
supported
on all four sides.
Must be able to
support weight
25-1/4"
of oven and
contents.
2 Min.
(3 Recommended)
Per Warming
Drawer
Requirement
NOTE: Additional
clearances between the cutouts
(CONT.)
23-1/2"
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
25-1/4" support weight
of oven and
contents.
2 Min.
(3 Recommended)
Per Oven
Requirement
NOTE: If you are
replacing an electric
double oven with the
combined installation
of an Advantium 120
and a single oven,
be larger than the 2" minimum shown.