EKOBO ONA Manual Del Usario página 3

TIPS FOR USE / EN
Carefully insert the glass flask (# 2) into the wooden base. Then insert
the stopper (# 3) into the glass flask. Finally, connect the adapter to the
mains socket (100/240V 50/60Hertz).
WARNING: Before inserting or removing the glass flask (# 2) make
sure you have removed the rotatable nozzle (# 3) to avoid any risk
of breakage. The blown glass parts are very fragile. Put a volume of
about one or two teaspoons of essential oils or a blend of essential
oils into the glass diffuser. The diffuser is now ready to operate. Turn the
power knob to start up your diffuser and adapt power distribution to the
desired diffusion.
Maintenance:
For its proper functioning, it is imperative that the essential oil diffuser
be cleaned using a special cleaning agent. Clean your diffuser 1 to 2
times a month. To do this, empty the essential oils from the diffuser,
pour in approximately two teaspoons of the cleaning agent and switch
on your diffuser for 3 to 5 minutes. Once this time has passed, pour off
the excess cleaning agent. You can start diffusing essential oils again.
Noise and Vibration:
To reduce noise as much as possible, we suggest you try it on different
surfaces. Carpet, fabric, wood or tiles could reduce or increase the
noise emitted by the pump. To avoid any possible vibration of the
glass stopper fitted into the glass flask, loosen the flask a little from
the wooden base. Delicately pull the glass flask while gently turning it
a few degrees to the left and right (do not rotate it far as this could risk
damaging the joint).
Contents:
- Mouth-blown glass diffuser chamber
- 1 diffuser nozzle
- 1 base housing electrical pump in bamboo fibre and wood
- 1 upper piece made from bamboo fibre.
- 1 electrical adapter and 1 set of instructions for use
Technical features:
Essential oil diffuser in wood and blown glass.
Variable diffusion power.
Diffuser: H = 205 mm, D = 100 mm
Power supply: Mains 100-240V 50/60 Hertz – EC STANDARD
3