Publicidad
Configuration
Conexión Connection
WIEGAND
- Establezca la salida Wiegand deseada del lector.
- Conecte el lector Wiegand al convertidor como se muestra en la imagen.
- Coloque el puente de direcciones del convertidor en la dirección deseada, 0 o 1.
- Configure los parámetros del lector en el software de la central.
- Set the desired Wiegand output of the reader.
- Connect the Wiegand reader to the converter as shown in the image.
- Set the address bridge of the converter in the desired direction, 0 or 1.
- Set the reader parameters in the control panel software.
GND
+12V DC
D0
D1
Buzzer
Reader's LEDs configuration
To configure the behaviour of the LEDS, check the reader's manual and put the
jumpers according to the table below.
Type
Jumpers position
1 wire
1 wire
2 wires
2 wires
2 wires
2 wires
2 wires
2 wires
2 wires
2 wires
z: High impedance/three state
LO: 0 Volts
HI: +5 Volts
Jumper closed:
Wiegand mode: disables the possibility to use a Wiegand keypad
Jumper opened:
Wiegand mode: a Wiegand keypad can be used on D0/D1 input; The Keypad
must be configured in Single Key - 8 bits Wiegand - Nibbles Complemented
Jumper opened: Address 0
Jumper closed: Address 1
Reader's LEDs colour
Orange
Red
Green
Address 0
Address 1
A
A
B
B
OFF
A
B
Publicidad
