Publicidad
FORCE
TM
ASSEMBLY
1. The hardware for attaching the upper handle to the lower can be
found in the parts bag. Install the upper handle (item #24) to
preassembled lower handles (item #25 and #26) by sliding the
upper handle over and down the inside of the lower handle. Using
bolt (item #12), washers (item 10) and lock nut (item #11), install
upper handle to lower handle. Finish installing the other side of the
upper handle assembly using screw and lock nut provided. The
TM
Aim-and-Shoot
is not attached, you will need to unroll the cable
and attach the ball end to the lever and seat the cable end into the
hole on the saddle clamp, with the cable running through the slot.
To keep the cable from being damaged, use three ty-wraps (item
#61) to secure it to the handle as shown, making sure that the cable
is not rubbing against the tire. (See Fig. 1)
2. Attach the front tire using the hardware located on the front wheel
bracket. Use a block to raise the front end of the unit off the ground.
Insert the wheel spacer (item #17) into the wheel and place in
between the bracket. Finally insert the bolt (item #20) through the
bracket, wheel, and spacer and secure with the nut (item #27). (See
Fig. 2)
3. Connect spark plug wire.
Part No 441247
601V BLOWER Owner's Manual
5
Fig. 1
Fig. 2
441247_B_LO
Publicidad
