Knape & Vogt SHELF-MADE 245-BK Instrucciones De Instalación

Installation Instructions
L-shape Shelving
245-BK
Tools Required (not included):
- Power Drill
- 3/16" Drill Bit or 3/32" Drill Bit
- Screwdriver
- Tape Measure
- Level
Installation Materials (included):
- (2) L-shape Shelves
- Mounting Hardware
Load Rating:
- 50 lbs each shelf when mounted
onto studs
2700 Oak Industrial Dr. NE
Grand Rapids, MI 49505
800-253-1561
www.kv.com
customer.service@kv.com
Installation
:
STEP 1: Select installation areas and mark keyhole locations on wall the correct
distance apart. Use a level to make sure the shelves will be straight, as shown in Figure 1.
STEP 2: Pre-drill pilot holes with a 3/32" drill bit in the marked locations. If a stud is
present, insert and fasten the screw leaving a 5/32" gap. If no stud is present, use a 3/16"
drill bit to bore out the 3/32" hole Insert the anchor and fasten the screw into the anchor
leaving a 5/32" gap, as shown in Figure 2.
STEP 3: Attach each shelf by placing the keyhole over the screws and applying a light
force downward, as shown in Figure 3.
x
Level
Back of L-Shaped Shelf
Figure 1
5/32"
Stud
Figure 2
Figure 3
©2015 Knape & Vogt. KV and the KV logo are trademarks of Knape & Vogt.
One of many alternate
mounting positions
2"
2"
5/32"
310462/0715