Goodson RRJ-350 Manual De Instrucciones

RRJ-350
Reluctor Ring Jig
For Chevy 350
RRJ-350
Please read instructions
before using.
© 2000 Goodson Shop Supplies
Instructions
Remove old reluctor ring. Perform machine work to crank-
shaft as desired. Then Slightly (.020"-.030") champher edge
of reluctor ring seat, and leading edge of ring. The reluctor
ring can be installed by heating to 450° and shrunk in align-
ment with aid of alignment tool. For proper positioning of tool-
ing and ring see illustration. External alignment pin indexes in
only 8mm hole in ring. (Ill A.) Internal alignment pin indexes
in only 11mm dowel hole in flywheel flange. (located in align-
ment with #1 crankpin)(Ill. B.)
CAUTION: Before installation of ring make sure location of
all machined parts are aligned precisely as illustrated. Shown
with GM #12559353 sensor ring.
Tech Tip: Reluctor Ring Jig is designed to be an alignment tool to properly
January 2014
locate the reluctor ring to the crankshaft.
B.
A.