Important - CREE LIGHTING THE EDGE ARE-EDG-DA Instrucciones De Instalación

3
4
Strip Outer
Strip Length 3/8"
Sheathing 3"
Puncture Grommet Face w/
Stripped Wire
5
2 of 3
Terminal Block
3 Conductor Cord
Seal Against Stop in
Grommet
ELECTRICAL CONNECTIONS AND FINAL
ASSEMBLY
STEP 1:
Route supply wire from the pole into the Universal
Mounting arm. See Figure 3. The supply wire
should be long enough to extend at least 3" into
the fixture arm.
STEP 2:
Strip 3/8" of insulation from supply wires and insert
one wire into each of the three holes in the grommet.
Push the supply wires thru the plug so that they
puncture and go thru the grommet. Pull the wires so
that 3" of wire extend from the grommet. See Figure
4.
STEP 3:
Install the grommet with wires into the wire channel
between the Universal Mounting arm and the fixture
arm. See Figure 3.
Note: The grommet should be installed with the
flange side flush to the rear wall of the fixture arm.
STEP 4:
Install the mounting clip with the two screws
provided. See Figure 1.
STEP 5:
Insert supply wires into the appropriate terminal
connection and make electrical connections per
"ELECTRICAL CONNECTION" section.
IMPORTANT: Damage to fixture will result when
improper voltage is applied. Verify fixture is suitable
for supply voltage by checking electrical label on
fixture.
STEP 6:
Connect the ground lead from the arm cover into the
appropriate terminal connection.
STEP 7:
Install arm cover over both the Universal Mounting
Arm and the fixture arm using provided screws. See
Figure 5.
NEMA RECEPTACLE (OPTIONAL)
STEP 1:
Remove protective cap.
STEP 2:
Loosen two flat head screws holding NEMA receptacle
to housing a few turns.
STEP 3:
Locate the N symbol on receptacle, representing
north.
STEP 4:
Rotate N approximately north, some photo controls
operate best somewhere between NW and NE.
STEP 5:
Once orientation of receptacle is complete, tighten
screws from Step 1.
STEP 6:
Install photo control (supplied by customer).
CI316X01R4_B