Threading The Upper Thread - Venga SWM 3000 Manual Del Usuario

into the bobbin case. Pull the thread tail again to ensure that it moves in a counter-
clockwise direction.

THREADING THE UPPER THREAD

Threading the upper thread is a simple process, but it must be done correctly in order to
achieve the correct sewing results.
Turn the Power On/Off & Speed Control Switch to the "off" position before threading the
machine.
Start by raising the needle to its highest position by turning the handwheel toward you
(counter-clockwise), and continue turning until the needle just starts to descend.
Raise the presser foot lifter, which will release the tension of the machine.
Note: This step is very important. If the presser foot is not raised so that the tension is
released, the result will be a large thread jam on the underside of the fabric when you
start to sew.
Turn the handwheel toward you until the needle and take-up lever are in their highest
positions.