Kenmore 580.76105 Manual Del Propietário página 11

PROCEDURE C
lil
To achieve rearward slope for unit draining,
remove the backing from the 1113/16" shim
strips and attach them as shown below in Fig.
21. The higher portion of shim is to be placed
in front of the rib on the base of wall sleeve.
h,0h_ r-
High
FIG. 21
16,,i 16, 1
FIG. 22
D Remove the metal rear grille and replace it with
the plastic rear grille.
Remove the Plastic rear grille
metal rear (
. FIG. 23
° Air conditioners coveredin this manualposean
excessiveweighthazard.Twoor morepeopleare
neededto moveandinstallthe unit.
To preventinjuryor strain,useproperliftingand
carryingtechniques when movingunit.
° Whenhandling the air conditioner,be carefulto avoid
cutsfrom sharpmetalfins on front and rearcoils.
° Makesureair conditioner d oesnot fallduring
removal.
• If unitdoesnotoperateafter installation check,to be
surethe circuitinterrupterhasnotbeentripped.Refer
to the Troubleshooting g uidefor resetprocedure.
_'_ Install the unit into the wall sleeve
new
_1_ Assemble trim as described in Step 6,
Procedure A.
-11-