Wireless Connection; Tws Function - QFX PBX-1212 Manual De Usuario

USER MANUAL
3- CHARGING THE SPEAKER
1- Full recharge takes 8-12 hours
2- Please use the supplied charging cable to charge the speaker.
3- When you are using your unit while it is plugged to an external power source,
battery switch can be ON or OFF.
4- To protect the lifespan of the built-in battery, be sure to fully charge your unit
on the same day the battery runs out. Not charging your unit right away can
affect the performance of the battery.
4- WIRED MICROPHONE INSTRUCTIONS
1- lnsert the microphone plug into the microphone input jack.
2- Adjust the microphone volume knob MIC VOL for proper volume.
3- Adjust the echo depth to the proper position.
4- Now you can start using your microphone.

5- WIRELESS CONNECTION

You can connect your compatible wireless devices such as a call phone,
computer etc., to listen to your audio tracks from this speaker.
Press the MODE button on the speaker, or press the MODE button on the
remote control to enter wireless mode, indicated on the LED display.
Using the native controls on your device, select "PBX-8122" in your settings to
pair, and once successful, you will hear a sound of notice on the speaker.

6-TWS FUNCTION

1. Turn on both devices of the same model and switch both devices to
Bluetooth mode.
2. The distance between the two units is within 50 CM.
3. Select one as the host (any one can) press the MODE button for 3 seconds,
and start to connect when the connection is successful, and the USB display
"BLUE" of the slave is bright.
4. Turn on the phone Bluetooth and connect to the QFX PBX-1212, the next two
speakers will automatically connect to each other.
5. Disconnect TWS: Press and hold the MODE button for 3 seconds. TWS has
been disconnected.
The exclamation mark inside an equilateral triangle is intended
to alert user of the presence of the important operating and
maintenance (servicing) instructions in the literature accompany-
ing the product.
The lightning flash with arrowhead symbol inside an equilateral
triangle is intended to alert User of the presence of un-insulated
"hazardous voltage" within the product's enclosure, which may
be of sufficient magnitude to induce a risk of electric shock to
persons
NOTES:
Please do not attempt to open the back cover or power adapter
as opening or removing the covers may expose you to
dangerous voltage or other hazards, and it will also cause the
restricted servicing to be disabled: There are no user servicing
components inside.