aquatechnik BBS 32 Instrucciones De Utilizacion página 20

M NU L RETURN OF COUPLING TOOL BBS 32
If the machine must be brought back to initial position
without completing the stroke, follow these simple
steps:
1) Unscrew protection nut located on the emergency
return device (C) as indicated in picture 14;
2) overturn the protection nut and screw it (by the
special threaded hole) to the emergency return
device (C) (picture 15);
pull protection nut downward until the equipment
3)
is released (picture 16);
4) unscrew protection nut, overturn it and screw it
back in order to restore its initial position;
restart work.
5)
M INTEN NCE
- Keep the conical pin clean and lubricated (by using the suitable grease (Item# 50825).
- In order to clean the equipment, use a cloth slightly soacked with a common, non-
aggressive detergent. DO NOT USE acid substances, thinners, solvents, and
powdered products which may damage its components.
- For a good operation of the Coupling tool BBS 32, it is recommended to perform
a servicing every two years conducted at aquatechnik mechanical dept.
- ny servicing work on the Coupling tool BBS 32 shall be performed at
aquatechnik mechanical dept. ny alteration of the equipment or its components
involve the cancellation of the warranty.
- In case of consistent loss of oil from the equipment, send immediately the Coupling
tool BBS 32 to aquatechnik mechanical dept. for subsequent inspection and
repairing. (Warning: avoid that leaked oil comes into contact with the eyes or skin.
Do not inhale or ingest. Do not disperse into the environment).
- void that the equipment get wet; water and liquids in general can damage the
electrical circuits.
Warning: During maintenance operations, make sure that the equipment is
disconnected from power sources (battery or outlet).
2 ENGLISH
BBS 32
(patented)
Picture 14
Picture 15
Picture 16