GE 16D3941P006 Manual Del Propietário página 16

Inserting the door panels.
Read these instructions completely and carefully.
Insert the Panels
Carefully push the door panels into the slots. Make sure that the top freezer panel is put in with the cut-out
at the upper left hand corner. When inserting the fresh food panel make sure the cut-out is at the upper
right hand corner.
Replace the Door Handle and Trim
Reinstall the full length handle and top handle cap. Loosely screw the handle onto the door. Place the cap
on the top of the handle and loosely screw down the cap. Lift the handle up and tighten the top screw on the
handle. Then tighten the handle cap screw so that the cap and handle fit flush. Tighten all the screws.
The fresh food panel is installed the same way.
3/4² (19 mm) or Raised Panel
A raised panel design screwed or glued to a 1/4² (6 mm) thick backing, or a 3/4² (19 mm) routed board
can be used. The raised portion of the panel must be fabricated to permit clearances of at least 2² (51 mm)
from the handle side for fingertip clearance and 1
cabinetry.
Weight limitations for custom panels:
Fresh Food: 38 lb. (17 kg) max.
Freezer Door: 20 lb. (9 kg) max.
16
2² (51 mm)
Clearance
Handle Side
/
1 1
Appearance
Clearance
Panel
Hinge Side
/ ² (32 mm) from the hinge side to avoid striking adjacent
1
4
1/4² (6 mm)
Thick Backing
² (32 mm)
4
Refrigerator
Door
3/4²
(19 mm)