Uline H-2811 Manual De Instrucciones página 2

PROBLEMS OR DIFFICULTIES
In some instances, when the time signal is unavailable,
the clock movement will continue to search for a
readable signal. If it cannot find a signal, the movement
may stop.
To reset, you must clear the memory by removing the
battery and inserting the battery backwards for 5
seconds. Then remove the battery and install it correctly.
Ideally, restart the clock after 10:00 PM, as the time
signal quality is generally better during night hours.
LOW BATTERY FUNCTION
The minute hand begins to advance in 2-second
increments when the battery is low. When this condition
is noticed, replace the old battery with a fresh one. After
installation, let the clock reset itself by receiving the time
signal. NEVER attempt to move the hands manually.
PAGE 2 OF 6
INSTRUCTIONS CONTINUED
CHECKING TIMEKEEPING ACCURACY
For the exact time, call the NIST time and frequency
service in Fort Collins at 303-499-7111 or visit their web
site at http://www.boulder.nist.gov/timefreq. If your clock
has received a signal and has set itself properly, it will
agree with the time broadcast.
Daylight Savings Time (DST): If you choose summer time
(DST ON), the clock runs the summer time when it has
received the DST signal. Otherwise, it keeps running
time normally.
EXTREME TEMPERATURES
The clock will operate in the temperatures range of 14˚
to 122˚F. Temperatures outside this range may affect the
performance of the clock.
1-800-295-5510
uline.com 0421 IH-2811