Kenmore 580.75281 Manual Del Propietário página 7

B Pull the bottom window sash down behind the
upper guide until they meet.
NOTE:
• Do not pull the window sash down so tightly that the
movement of sliders is restricted. Attach the cabinet
to the window inner sill by driving the screws (ITEM F)
through the cabinet into window inner sill.
• The cabinet should be installed with a very slight tilt
downward by 1/4" from level.
Window sash Ipper guide
Side curtain
FIG. 10
D Expand side curtains to fill opening.
Attach each side curtain to the window sash using 4
screws (ITEM G). (FIG. 11)
_r[_ Attach the window locking bracket (ITEM L) with
a screw(ITEM G). See FIG. 12.
FIG. 12
_11 DRAINAGE
A drain hole is provided at the rear of the air
conditioner unit. Refer to the drain method below:
• Remove the hole rubber from the basepan.
• Connect a drain elbow of 9/16" inside diameter to
the drain pipe.
• Connect a drain hose of 9/16" inside diameter to the
drain elbow. (Drain hose is not supplied.)
Drain
pipe
FIG. 13
Drai/
elbow elbow
Drain
hose
_"_ Slide the air conditioner into the cabinet. (FIG. 14)
CAUTION: For security purposes, reinstall side
screws that were removed in step 1.
Screw
14
[]Cut the foam strip (ITEM K) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 15)
FIG. 15
_1 Adjust the vent before the decorative front is
attached. (FIG. 16)
Straighten the lever, as shown. Pull down part _)to
align with part (_.
FIG. 16
-7-