Fixing Of Barrier; Fixing Of A Standard Barrier; Fixing Of A Rotating Barrier; Fixing Of The Electronic Part Of The Barrier - EB TECHNOLOGY ACTIVE-S Serie Manual Del Usuario

12
2

FIXING OF BARRIER

2.1

FIXING OF A STANDARD BARRIER

2.2

FIXING OF A ROTATING BARRIER

2.3

FIXING OF THE ELECTRONIC PART OF THE BARRIER

To fix the electronic part, it is sufficient to plug a fixing screw in the first module. (Picture pag. 11)
To fix the barrier make as follow:
1. Fix the point for the fixing hole (5mm) E and F and check the
right position of the module A with the covers B and C. The hole
G should be just over the fixing hole F
2. Make a 5mm holes, put the plug D
3. Fix the cover B to the hole E with self-tapping screw H
4. WARNING!!! If the barrier is installed outside, make a drainage
hole in the lower part of the cover C.
5. Pass the cables in the back of the cover C, make the connec-
tions of the barrier A.
6. Plug the cover C in the barrier A , and take off the cables in
excess.
7. Fix the cover C with the a self-tapping screw H.
To fix the rotating barrier make a s follow:
1. Fix the point for the fixing hole (5mm) E and F and
check the right position of the module A with the covers
B and C with bearing I and L . The hole G should be
over the fixing hole F.
2. Make a 5mm holes, put the plug D
3. Fix the cover B to the hole E with self-tapping screw H
4. WARNING!!! If the barrier is installed outside, make a
drainage hole in the lower part of the cover C.
5. Before make the connections of the barrier and then
plug the covers B and C in the barrier A. Plug the co-
vers and take off the cable in excess.
6. Plug the upper part of A, B, C in the part I.
7. Plug the part L in the lower part of the cover C and fix
with self-tapping screw H.
8. To fix the module of the rotating support, make a
2.5mm hole in the pivot pin and fix the cover with a
small self-tapping screw.