Wall Mounting - Tripp-Lite SS240806 Manual Del Propietário

Wall Mounting

All Power Strip models feature clips for horizontal or vertical mounting on a variety of surfaces.
The user must supply other mounting hardware (screws, etc.) and determine its suitability for use
with the chosen mounting surface.
1
Mark a straight horizontal or vertical line where
you want to mount the Power Strip. At each end
of the line, mark where the edges of the Power
Strip will be located. Place a mounting clip on
the mounting surface 1" in from these edges
and mark where the screws must be driven into
the wall. For strips longer than 48" (120 cm),
also mark a screw hole for a third mounting clip
midway between the other two.
2
Keyhole Mounting: Drive #8 screws directly
into the mounting surface. Snap the mounting
clips onto the Power Strip
Power Strip on the screws by the keyhole slots
on its mounting clips
3
Clip Mounting: Drive #10 screws through
washers, through the centers of the mounting
clips and into the mounting surface
the Power Strip inside one edge of the mounting
clips, then snap the Power Strip into place
Specifications
Amperage
Model
SS240806
SS3612
SS361220
SS480806
SS7415-15
SS7619-15
14-10-111-9333D1.indb 3
2a , then hang the
2b .
3a
Outlet
Rating Qty. x Type
15A 8 x 5-15R
15A 12 x 5-15R
20A 2 x 5-20R,
10 x 5-15R
15A 8 x 5-15R
15A 16 x 5-15R
15A 24 x 5-15R
1
2a
2b
. Place
.
3b
3a
3b
AC Suppression Input
Rating Plug
1050 joules 5-15P
1050 joules 5-15P
1650 joules 5-20P
1650 joules 5-15P
1650 joules 5-15P
1650 joules 5-15P
3
Cord Overall
Length Length Breaker
6 ft. 24 in. 15A
15 ft. 36 in. 15A
15 ft. 36 in. 20A
6 ft. 48 in. 15A
15 ft. 48 in. 15A
15 ft. 72 in. 15A
11/6/2014 9:19:05 AM