User Maintenance - Andis SBLC Manual Del Usuario

2-SPEED OPERATION
Your Andis clipper is equipped with two cutting speeds. The speeds are adjusted
using the switch (Figure D). Setting "O" indicates the off position, Setting "1" is low
speed and Setting "2" is high speed. After using your Andis clipper, rewrap cord
and store in a safe place.
CHARGING INDICATOR LIGHT
When the clipper is running, a green charging indicator light means the battery
has a strong charge (Figure C). When the light turns red, the battery may not hold
enough charge to complete a large clipping job, and should be recharged as soon as
possible. If the clipper powers OFF, move the power switch to the OFF position and
plug the adapter cord directly in the receptacle on the bottom of the clipper (Figure A).
Automatically powering off protects the lithium-ion battery and is not a malfunction.
The clipper will resume normal operation when it is recharged.

USER MAINTENANCE

The internal mechanism of your motor clipper has been permanently lubricated by
the factory. Other than the recommended maintenance described in this manual, no
other maintenance should be performed, except by Andis Company, or an Andis
authorized service station. To contact Andis directly, please call our Customer
Support Team at 1-800-558-9441 or email us at support@andisco.com.
REMOVING BLADE SET
To remove blade set, first make sure your clipper motor is switched off, then push
down on blade with one or both thumbs (Figure E) and slide blade off blade hinge
(Figure F). Some models are equipped with a blade locking mechanism. To remove
the blade, press down on blade locking mechanism while pushing blade off of
clipper. If your blade hinge should snap closed and is flush with the clipper, use
a small standard screw driver to pry the tongue of the hinge out (Figure G).
NOTE: Hair may accumu late in the front cavity of the housing under the blade. If
this hap pens, you can clean out the hair by brushing out the cavity with a small
brush or an old toothbrush while the blade is off the clipper.
REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper (Figure F), and with the clipper turned "ON", push the blade towards the
clipper to lock into position.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. If
you have a detachable blade unit, you can change your blade in order to maintain a
comfortable temperature; using multiple blades of the same size is popular among
professionals.
6