Kohler K-1239-HB Manual De Instrucciones página 2

Pump/Control Access
20" (50.8 cm) W x
15" (38.1 cm) H
18"
(45.7 cm)
1-11/16"
(4.3 cm)
3-1/2"
(8.9 cm)
Product Information
Applicable product:
Drop-in rim style with heater, custom pump
Fixture*:
Bathing well:
Basin area, bottom 46" (116.8 cm) x 24" (61 cm)
Basin area, top 54" (137.2 cm) x 27" (68.6 cm)
Weight 110 lbs (49.9 kg)
To overflow:
Water depth 14" (35.6 cm)
Capacity 63 gal (238.5 L)
* Approximate measurements for comparison only.
Drop-in cutout dimensions:
58" (147.3 cm) x 34" (86.4 cm)
V
Pump: 1-speed 120
Heater: 1.5 kW 120
Minimum access panel
pump/control (required):
1014700-1-B
7-1/2" (19.1 cm) Max
8-11/16" (22.1 cm)
60" (152.4 cm)
2-7/8" (7.3 cm)
3"(7.6 cm)
K-1239-HB
Hz A
60 7.5
60 12.5
20" (50.8 cm) W x
15" (38.1 cm) H
No change in measurements if connected with
drain illustrated. (K-7161-AF or K-7161M-AF)
Recommended Faucet Location
20"
(50.8 cm)
1" (2.5 cm)
Required Electrical Service (2 required)
Two dedicated circuits required, each protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Pump/control
Heater
Locate the outlets behind the whirlpool and within 24" (61 cm)
of the pump and heater.
Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum of
44 lbs/square foot (215 kg/square meter) loading.
The apron must be installed before the finished floor and wall
materials are installed.
If installing a rim-mount faucet, make sure there is no interference
with the drain overflow and circulating system before drilling any
holes. Consult local and national codes for minimum air gap
requirements if installing a spout on the faucet deck.
Pump must be relocated to custom position at the time of
installation. Provide adequate clearance.
This fixture conforms to ANSI Standard Z124.1.2. All dimensions
are nominal.
2
1-1/2"
(3.8 cm)
Drop-in Rim
Detail
36" (91.4 cm)
18-1/2"
(47 cm)
1-1/2" OD
120 V, 15 A, 60 Hz
120 V, 15 A, 60 Hz
Kohler Co.