Operating Instructions
PREPARING AND USING THE SPRAYER
1. Remove cap.
2. Mix solution in a separate container, following the chemical manufacturers' guidelines.
3. Pour pre-mixed solution into sprayer and firmly screw the cap on.
4. Place the sprayer on your back and pressurize by pumping approximately 10-15 times. For best results, the sprayer should be pumped
every 5 seconds on a continuous basis. This will maintain the spraying pressure.
5. Always lubricate the seal on the cap as well as the check valve as this will extend the life of the seal and is important for maintaining
proper seal with no leaks.
CLEANING AND MAINTAINING THE SPRAYER
After each use, clean the tank thoroughly. If some spray solution remains, dispose of properly and drain tank completely. Follow
recommendations of chemical manufacturer for proper disposal of any remaining spray solution. Pumping causes air to be taken in and
the remaining liquid to be discharged. Pump until all liquid and air are completely discharged through the nozzle. Refill the tank with a few
quarts of soapy water (a mild dish detergent is recommended) and discharge as previously instructed. If necessary, repeat this procedure
several times to insure that the sprayer is clean. If the flow control is removed, the pump can quickly be flushed. Sporadic spray distribution
is caused by a clogged nozzle. If necessary, remove and clean nozzle.
MAINTENANCE AND STORAGE
After use, the sprayer should be properly cleaned and stored away from direct sunlight to prevent UV damage. After removing the piston or
mounting a new collar, treat both the collar and the piston with a lubricant (grease or petroleum jelly). Before storing for the winter, be sure
that all liquid is completely drained from the tank, lines and air chamber. (Refer to CLEANING THE SPRAYER instructions above). Leave flow
control locked open. Regularly inspect hose, wand, pump, tank and flow control for wear, damage or leaks. Avoid excessive wear by regular
lubrication and a prompt and thorough cleaning after each use.
Warranty
LIMITED WARRANTY
TurfEx warrants to the original purchaser only that this product will continue to function as intended if used in accordance with operating
instructions for as long as the original purchaser owns the product. If the product fails to function as intended – DO NOT RETURN IT TO
THE STORE – call CUSTOMER CARE at 1-800-5-TURFEX. We will, at our option, repair or replace any non-functioning parts without charge
(shipping charges will apply.) TurfEx shall have the option of requiring the return of the non-functioning product together with the proof
of purchase to establish a claim under this warranty. This warranty does not apply to damage resulting from accident, misuse, neglect,
alterations, operation not in accordance with instructions, or normal wear of o-rings or seals. Any implied warranties, including the implied
warranty of merchantability and fitness for consumer use, are limited to the duration specified above. TurfEx's liability is limited solely to
the repair or replacement of the non-functioning product or part. TurfEx excludes liability under this warranty for any and and incidental and
consequential loss or damage. Some states do not allow limitations on how long an implied warranty lasts, or the exclusion or limitation of
incidental or consequential damages, so these limitations or exclusions may not apply to you. This warranty gives you specific legal rights
and you may have other rights which vary from state to state.
© TrynEx International 2013 (REV A) F50913
4