BaByliss PRO VIBEFX FXSSM1 Instrucciones De Operación página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS
1. Before using the massager for the first time, charge continuously for 2
hours. Maximum battery capacity will only be reached after 3 charging and
discharging cycles.
2. Make sure the switch on the massager is in the OFF position. Connect the charging
jack into the receptacle on the bottom of the massager. Plug the adapter into
any electrical outlet (at the voltage listed on the label affixed to the adaptor). The
charging indicator will light up to indicate that charging has begun. Charging is
complete after 90 minutes.
3. The adapter may become warm while charging. This is normal.
4. Preserving the batteries: In order to maintain the optimum capacity of the
rechargeable batteries, the massager should be recharged for 2 hours approximately
every 6 months.
5. Turn the switch to HI for high-speed function and LO for low-speed function.
6. Make sure the switch is in the OFF position when the massager is not operating.
WARNING:
Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user's authority to operate the
equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
FXSSM1(MG) IB-15811A.indd 5-6
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications not expressly approved by Conair Corporation,
the manufacturer of this product and the party responsible for compliance, could void
the user's authority to operate the equipment.
FOR DIRECT PLUG-IN OPERATION
Make sure massager is off. Connect charging jack into the receptacle at the end of
massager and plug the adapter into power outlet.
ON/OFF SWITCH
To operate, simply slide switch to low or high-speed position. To stop operation, set to
the OFF position.
CAUTION
1. Consult your doctor before using in case of illness or medical condition, including
but not limited to pacemaker use, pregnancy, cancer, infection, fracture, or persistent
pain.
2. Do not use if you have any of the following conditions: diabetes, tuberculosis, benign
or malignant tumors, phlebitis or thrombosis, hemorrhages, open or fresh wounds,
ulcerated sores, varicose veins, poor circulation or bruised, discolored, burned,
broken, swollen, or inflamed skin or heat sensitivity.
3. This product should not be used by any individual suffering from a condition that
limits or altogether inhibits the user's capacity to feel or have sensation in any part
of the body.
4. If you experience pain in a muscle or joint for a prolonged period of time,
2020/2/20 1:08 PM

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vibefx fxssmg

Tabla de contenido