Product Overview - Cramer 2902986 Manual Del Usuario

Product Overview

EN
Your machine has been engineered and manufactured to high standard for
dependability, ease of operation, and operator safety. When properly cared for, it
will give you years of trouble-free performance.
Know your Pole Hedge Trimmer Head
1. Blade
2. Pivot Button
3. Scabard
4. Auxiliary handle
5. Rubber protector
6. Lower shaft
7 . Release button
8. knob
Assembly
•
This product requires assembly.
• Carefully remove the product and any accessories from the box. Make sure
that all items listed in the packing list are included.
•
Inspect the product carefully to make sure no breakage or damage
occurred during shipping.
•
Do not discard the packing material until you have carefully inspected and
satisfactorily operated the product.
Install the Pole Hedge Trimmer Head
1 Remove the rubber protector.
2 Loosen the knob on the coupler.
3
Push in the release button located on the lower shaft. Align the release
button with the positioning hole and slide the two shafts together. Rotate the
lower shaft until the button locks into the positioning hole.
4 Tighten the knob securely.
NOTE: If the button does not release completely in the positioning hole, the
shafts are not locked into place. Slightly rotate from side to side until the button is
locked into place.
2
cramer.eu
Adjust the Trimmer Head Angle
The trimmer head pivots 180° and can be locked into 13 positions within that range.
Operation
Tips for Optimum Use
(See Figure 2)
Maintenance
Clean the Machine
Clean the machine thoroughly to remove all dust and debris, after every work session.
1 Hold the auxiliary handle.
2 Pull back and hold the pivot button.
3 Use the auxiliary handle to adjust the trimmer head angle.
4 Release the pivot button once the trimmer head is in the desired position.
5 The trimmer head should lock securely in place.
(See figure 4-5)
• Start by trimming the top of the hedge. Slightly tilt the tool (up to 15° relative
to the line of cut) so that the blade tips point slightly towards the hedge. This
will cause the blades to cut more effectively. Hold the tool at the desired
angle and move it steadily along the line of cut. The doublesided blade allows
you to cut in either direction.
• In order to obtain a very straight cut, stretch a piece of string along the length
of the hedge at the desired height. Use the string as a guideline, cutting just
above it.
• In order to obtain flat sides, cut upwards with the growth. Younger stems
move outwards when the blade cuts downwards, causing shallow patches
in the hedge.
• Take care to avoid any foreign objects. Especially avoid hard objects such as
metal wire and railings, as these could damage the blades.
• Regularly oil the blades.
•
To reduce fire hazards, keep the machine and, in particular, the motor free
of leaves, branches or excessive grease.
• Always clean the machine after use with a damp cloth dipped in neutral
detergent.
• Remove all traces of humidity using a soft damp cloth. Humidity can
generate risks of electric shocks.
(See figure 3)