Work C-72 Instrucciones De Usuario página 7

SPEED SETUP
This configuration adjusts the internal CHASE speed. The number of channels
in a CHASE can be adjusted between 1 & 72 channels. This CHASE can not be
edited. To change the CHASE speed:
1.- Hold pressed the MENU button during 3 seconds.
When the LCD display begins to blink, press quickly the MENU button three
2.-
times to activate the setup. This will be indicated by the blink of the message
SPXX in the display, where XX is a number.
Use the UP & DOWN buttons (4 & 6) to adjust the speed. The values that
3.-
can be selected are between 01 & 99. A configuration of 0 is the fastest
CHASE speed of 0,1 sedconds. A configuration of 99 is the slowest speed
of 10 seconds.
4.-
When finish your selection, press the MENU button (5) twice to exit of this
function and confirm your selection.
START CHANNEL SETUP
This configuration allows you to select the start DMX channel which will trigger
the controller. To change this configuration :
Hold pressed the MENU button during 3 seconds.
1.-
When the LCD starts to blink, ensure the DMX led placed at the left side of
2.-
the display (3) is blinking too. If not, use the UP & DOWN buttons (4 & 6) to
select the DMX mode.
3.- Staying in the DMX mode, press quickly the MENU button (5) once only to
activate the DMX mode. This will be indicated by the message AXXX blinking
in the display.
4.- Use the UP & DOWN buttons (4 & 6) to select the desired start channel. This
channel cab be between 1 to 512.
5.- When finish your selecti press four times the MENU button to exit of this
function and confirm your selection.