Telcoma PASSO FM400 Instrucciones Para La Instalación página 36

GB
MEMORISING CHANNELS ON THE RECEIVER
During this operation, refer to the receiver instructions.
- Enter a USER code assigned to channel 1 of the virtual remote control (keypad).
- Press the self-learning button on the Telcoma receiver or control unit.
- Press the key # on PASSOFM400 to start transmission; the red led ¤ lights up.
- As soon as the receiver memorises the code (see receiver instructions) release
the key # on the keypad.
The entire operation must be completed within 5 seconds.
Repeat the same operation to memorise the other 3 channels of the keypad as
required.
EXAMPLE OF COMPLETE INSTALLATION
# (2 sec.) 123456# 90# 2233# 2233#
# (2 sec.) 2233# 01# 1234# 2468#
# (2 sec.) 2233# 03# 6969#
Time-out after 10 sec. The keypad turns off.
start memorisation on the receiver
1234#
6969#
36
replacement of MASTER code
123456 with 2233
entry of USER codes 1234 and
2468 assigned to channel 1 of
the keypad
entry of USER code 6969
assigned to channel 3 of the
keypad
transmission of channel 1 for
memorisation on the receiver
transmission of channel 3 for
memorisation on the receiver