Daikin website (publicly accessible). Installing the indoor unit ............5.2.1 To install the mounting plate ........▪ The full set of latest technical data is available on the Daikin Business Portal (authentication required). 5.2.2 To drill a wall hole ............10 5.2.3...
2 Install 2 screws (class 20~35) or 3 screws (class 50~71) back manner. on the front grille. 3 Install the air filter and then mount the front panel. Installation manual FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Daikin room air conditioner 3P512025-8R – 2019.12...
5 To re-install the cover, first hook the bottom tab onto the plate pocket. electrical wiring box, and slide the cover into the 2 upper tabs. 116.5 (mm) FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Installation manual Daikin room air conditioner 3P512025-8R – 2019.12...
▪ Pipe length. Keep drain piping as short as possible. ▪ Pipe size. If drain hose extension or embedded drain piping is required, use appropriate parts that match the hose front end. Installation manual FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Daikin room air conditioner 3P512025-8R – 2019.12...
Página 11
To check for water leaks 2 Wrap the drain hose and the refrigerant pipes together using 1 Remove the air filters. insulation tape. FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Installation manual Daikin room air conditioner 3P512025-8R – 2019.12...
Do NOT connect the power supply to the indoor unit. This Terminal block could result in electrical shock or fire. Electrical component block Cable clamp 5 Strip the wire ends approximately 15 mm. Installation manual FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Daikin room air conditioner 3P512025-8R – 2019.12...
▪ Do NOT push the refrigerant pipes onto the bottom Drainage frame or the front grille. Make sure drainage flows smoothly. Possible consequence: Condensate water might drip. FTXP50~71M2V1B + FTXF20~71A2V1B + ATXF50~71A2V1B Installation manual Daikin room air conditioner 3P512025-8R – 2019.12...
Daikin website (publicly accessible). Prerequisite: Power supply MUST be in the specified range. ▪ The full set of latest technical data is available on the Daikin Prerequisite: Test run may be performed in cooling or heating Business Portal (authentication required).