Viega MiniBloc Instrucción Del Producto

Product
Instructions
Viega MiniBloc™ Mounting Instructions
®
Vertical
Mount
Horizontal
Mount
This document subject to updates. For the most current Viega technical literature please visit www.viega.us
Click Services -> Click Electronic Literature Downloads -> Select Product Line -> Select Desired Document
Viega LLC, 100 N. Broadway, 6
PI-PF 520531 0514 (Mounting the MiniBloc)(EN ES FR)
3
Vertical
Mount
Horizontal
Mount
5
Floor • Wichita, KS 67202 • Ph: 800-976-9819 • Fax: 316-425-7618
th
1
The MiniBloc shall be installed using the ManaBloc
installation instructions (included) and this instruction sheet.
1. For proper bracket spacing, measure distance between
the center ribs of the first and last MiniBloc module.
Mark this distance on the selected mounted surface.
2. Align the outside edge of each bracket within each
end mark. Mounting brackets shall be mounted level
and parallel to each other before affixing the MiniBloc
manifold. NOTE: Use both mounting brackets provided
with each MiniBloc manifold. Ensure the mounting
2
surface is suitable to support the weight of the
manifold and attached tubing when filled with water.
3. Use two wood screws per bracket, 1" or longer, to
prevent misalignment.
4. Position bottom metal tie-rod into the bottom clip of
the mounting brackets then roll manifold toward top
clip. The MiniBloc may be mounted either vertically or
horizontally.
5. Complete mounting by firmly pushing the MiniBloc
toward the top clip of the mounting brackets which
4
should spread and snap over top metal tie-rod.
®
1 of 2