Plantronics Clarity C120 Manual Del Usuario página 6

C120 INSTALLATION
CONNECTING THE C120 TRANSMITTER
1. Connect the Power
Connect the AC Adapter into the DC12V port
located on the back of the base (Fig. 2). Plug the
DC12V
AC Adapter into a wall outlet.
2. Select the Appropriate Audio Cord
FIG. 2
A. RCA Cord: has red and white connectors
on both ends. Used to connect stereo TV's,
VCR's, or audio equipment to the C120 base
unit. See Figures 3 and 4.
B. RCA to 3.5mm Cord: has red and white
connectors on one end and a 3.5mm headset
plug on the other. Use this cord to connect
R
TV
to audio devices that only have a headset jack.
W
STEREO MONO
See Figures 6 to 9 on page 9.
FIG. 3
3. Configuring the Audio
A. RCA to RCA Mode
This is suggested for highest sound quality. This
VCR
mode should be used if the television (or other
FIG. 4
audio equipment) has two RCA audio ports
(red and white). See Figures 3 and 4.
Note: The television is the
There are two types of ports on the back of a
best solution because it is
television or other audio device, ones that receive
a source for all the audio
from the DVD player, VCR, incoming sound, and others that transmit out-
cable, and other devices.
going sound. The C120 needs to be plugged into
For example, if you plug into
the ports that transmit the outgoing sound.
DVD player, only audio from
To find the correct ports on the back of the
DVD's will be heard.
television or other device, look on the back of
the device for the red and white ports that are
labeled "Audio Out." Most of the red and white
ports on the television are labeled "IN" for input,
and the C120 needs to be connected to a port
labeled "OUT" to receive the outgoing sound.
8
C120 INSTALLATION
If you have digital cable or satellite, plug the
R
TV
C120 into the digital cable or satellite box
W
if possible.
Connect the RCA jacks to the output of the
FIG. 5
TV or VCR. Connect the other end of the
cord to both the left and right RCA ports
STEREO MONO
TV
on the C120 base. Next, select "STEREO" on
3.5mm jack
the "MONO/STEREO" switch on the base.
FIG. 6
If the television (or other audio equipment)
has only one RCA port, connect the left (white)
RCA jack from the output into the left (white)
RCA port of the base. The right (red) jack
should remain unplugged on both ends. Next,
Computer
select "MONO" on the "MONO/STEREO"
FIG. 7
switch on the base. See Figure 5.
B. RCA – 3.5mm Mode
This should be used if the television (or other
CD Player
audio equipment) has only a 3.5mm jack.
FIG. 8
This enables the C120 to be used with
computers, CD players, stereos, MP3 players,
MP3 and other related products.
Player
Use the cord with the RCA jacks on one end
and the 3.5mm jack on the other. Plug the
FIG. 9
3.5mm jack into the device and connect the
RCA jacks in the C120 base. See Figures 6
to 9. Next, select "STEREO" on the "MONO/
STEREO" switch located on the C120 base.
9