Turning On; Standby/Automatic Switch-Off; Battery Life And Standby Time; Battery Almost Empty - Marmitek BoomBoom 75 Modo De Empleo

3.9

Turning on

Switch the BoomBoom 75 power switch up. The blue LED will light
for 2 seconds.
The BoomBoom 75 will then automatically link to the last device it
was connected to. Only 1 device can be connected at once with
the BoomBoom 75. If your device does not connect automatically,
go to the device's Bluetooth settings and select the
BoomBoom 75. A connection will then be made.
3.10

Standby/automatic switch-off

If the BoomBoom 75 is in connecting mode and no connection is
made within 10 minutes, the BoomBoom 75 will switch to standby
setting (blue LED blinks 2 times every 3 seconds). If no
connection is made for 20 minutes, the BoomBoom 75 will
automatically switch off. If you wish to use the BoomBoom 75, you
must switch the power switch off and on again.
3.11

Battery life and standby time

Once the battery has been fully charged it will last for about 4
hours at 70% volume. Standby time is around 100 hours. You can
use the BoomBoom 75 with the mains adapter supplied. The
battery then remains charged.
! Please charge the BoomBoom 75 at least once every 2 months
when not in use.
! Press the button and connect with the power supply to reset the
BoomBoom 75 when the BoomBoom 75 is dead during use.
3.12

Battery almost empty

When the BoomBoom 75's battery is almost empty, the red LED
will blink once every 30 seconds and you will hear a warning
signal 4 times via the sound system. Follow the steps given earlier
to charge the battery.

3.13 Delete paired devices

In standby status, long press the button for 5 seconds. The Blue
and Red LED will flash once to clear all paired devices. Turn
OFF/ON the BoomBoom 75 to pair to a new Bluetooth device.
8 © MARMITEK