Kenmore 580.74122 Manual Del Propietário página 7

E'_ Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
ITEM E
Cabinet
INDOOR OUTDOOR
FIG. 10
_J_ Place the sill supports with the cabinet on the
window sill's selected position.
_1_ The cabinet should be installed with a very
slight tilt (about 1/4") downward toward the outside
(FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
.<
ITEM B FIG. 11
_1 Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the Lower Guide into the
window inner sill (FIG. 12).
TrackSash
_ _Lower Guide
I_?"_ ITEMF
ITEMB FIG. 12
_"_ Pull each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G). (FIG. 13)
ITEMG
- FIG. 13
_qJ Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
_ jlTEM G
FIG. 14
_'! DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight
tilt(I/4") downward to the outside for proper
drainage of excess condensed water through the
drain pipe. (FIG. 15)
"_BASE PANREAR
DRAIN
_OM FIG. 15
_"'_ Slide the chassis into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side
screws you removed in step 1.
-7-
Cord
Screw
Screw FIG. 16
_1"_ Cut the foam strip (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
FIG. 17
_oThe vent control handle must be
straightened
re the decorative front is attached.
Pull out part (_)to align with part (_.
d,_'- . ...
..--. -_.
FIG. 18