Store The Cleaner When Not In Use - Aqua Products EP37 Serie Manual Del Usuario

10
4. Press the interior latch and remove the
filter canister lid (Figure 11).
Figure 11. Remove Filter Canister Lid
5. Using a hose with clean water, rinse the
filter canister and lid to remove all debris
(Figure 12).
Figure 12. Rinse the FIlter Canister
6. Replace lid on the canister and then
replace canister back into the cleaner
body.
7. Plug the power cord back into the control
unit and store the cleaner out of direct
sunlight for next use.

Store the Cleaner When Not in Use

The cleaner must be cleaned regularly using
slightly soapy clean water. Do not use solvents
such as trichlorethylene or its equivalent. Rinse
the cleaner generously using clean water. Do not
let your cleaner dry in direct sunlight near the
pool.
1. Disconnect cleaner from the power
source.
2. Start at the cleaner head, remove all
coils and tangles from the floating cable.
Lay the cable in the sun to loosen any
tangling memory
(Figure 13).
3. Disconnect the cable from the control
unit. Replace the protective cap on the
control unit.
Figure 13. Untangle the Floating Cable
4. Loosely coil the floating cable starting
at the cleaner and moving toward the
connection point at control unit.