Metrolight SmartHID Guía De Inicio Rápida página 4

For MH Lamps: use only PULSE START lamps
Visit Metrolight's web site for Lamp Compatibility List (www.metrolight.com)
Output cable, terminal & sockets should be suitable for at least a 4KV ignition
Recommended output cables: Use silicon isolated cables, 1.5mm
Lamp control gear does not rely upon the luminaire enclosure for protection against
accidental contact with live parts
IMPORTANT: Always verify that the t
installation method
BALLAST Mechanical Mounting
*
5cm
Typical values may be modified to comply with note marked IMPORTANT above.
Where possible, install the SmartHID Ballast vertically.
Mount the SmartHID Ballast as far away from the lamp reflector as possible.
Mounting should be secure flat/flush to plate/bracket
Label data
Always verify lamp compatibility and technical data as labeled on the ballast/driver
North American Office
Metrolight Inc
34197 Pacific Coast Highway
Dana Point, CA 92629
Tel. (949) 542 7048
Fax (949) 542 7050
Metrolight Quick Installation Guide up to 600W
P/N 8638732 Rev AA 13June12
M3
2"
M3
Voltage value
Lamp Type
International Office
Metrolight Ltd
POB 8194, New Industrial Park
Netanya 42160,
Israel
Tel. +972 (9) 8633060
Fax. +972 (9) 8633050
is lower than the marked value regardless of
c
5cm
2"
Individual Ballast address
Distributor info.:
2
, 5KV minimum rated
Aluminum
plate
3mm
1/8"
Ballast name
Lamp power rating
Lamp operating
power (Output
power after 15
minutes)