Start Up Instructions; List Of Materials; Mounting The Machine; Overload Protection - Garland Roll&Comb 141 EUS Manual De Instrucciones

English

5. START UP INSTRUCTIONS

5.1. LIST OF MATERIALS

This machine includes the following elements
that you will find inside the box:
• Engine
• Tube connecting screw
• Connecting wing nut
• Drums
• Instruction manual

5.2. MOUNTING THE MACHINE

Introduce the superior tube into the inferior
tube and connect using the screw and wing nut
provided.
Place the handle in the most comfortable
working position.
5.3. CHECKING POINTS PRIOR TO WORKING
The current and tension supplied must coincide
with those in the characteristics label. Prior to
starting work check that the machine works
adequately and all security measures work.
Check the machine and look for any loose
pieces (screws, nuts, housing etc) and for any
damages. Tighten, repair or replace those
pieces that you have found to be in a bad state.
Ensure that there are no leakages. Do not use
the machine if damaged or not well regulated.
5.3.1. CABLE FIXATION
Only use cable
extensions that are
approved for outdoor
use. The cable section
must be at least 1.5mm
and the cable extension
should never be longer
than 25m and must be
completely unrolled
before starting to work.
Fix the extension of the machine by inserting
cable in the hook on the handle and plug onto
the machine.
5.4. START UP AND STOPPAGE
Start up the machine:
Press the security button
(1) and without letting go,
press the On/Off switch (2).
Stoppage of the machine:
Let go of the On/Off switch
(2).

5.5. OVERLOAD PROTECTION

This machine has a security switch that will
disconnect the machine If the machine detects a
high level of resistance on the blades.
If you detect that the machine does not start
when the switch is on the On position, the
probable cause will be that the security switch is
activated. In this case disconnect the machine
from the mains, place the switch on the Off
position, check that the blades are clean and
have no elements that impede the blades from
turning and wait 15 minutes before starting the
machine again.

6. MACHINE USAGE

Use this machine only for those purposes for
which it has been designed. The usage of this
machine for any other purposes is dangerous
and can cause damages to the user and the
machine.
Do not get anywhere near to the comber when
the machine is working.
If you lose your balance or fall, let go of the
handle switch immediately.
Do not solely rely on the security measures of
this machine. Use common sense at all times.
Do not use this machine if you are tired, sick,
are taking medicines, or if under the effect of
alcohol or drugs. Lack of sleep and fatigue can
cause accidents and damages.
Do not use this machine at night, with fog or
with reduced visibility. You must see the working
area clearly at all times.
Limit the usage of the machine to 10 minute
stints and rest for a further 10 to 20 minutes in
between sessions.
8/32
1
2