Publicidad
Idiomas disponibles
Idiomas disponibles
7. Locate upper and lower foot rail brackets.
8. Position upper and lower foot rail brackets as shown. Fasten to
pillar using 2 screws (A) for each pillar.
9. Slide foot rail down over heater assembly. Position foot rail as
shown, and fasten to brackets with 1 bolt (B) and 1 nut (C) for
each pillar.
Foot Rail
Upper
Foot Rail
Bracket
Bolt (B)
Nut (C)
Lower Foot
Rail Bracket
Pillar
10. Slide top assembly into position as shown, making sure that grate
tabs engage slots on underside of reflector. Fasten in place with
1 screw (A) through each pillar.
123224-01A
11. Connect regulator to gas cylinder. Gas cylinder will set inside of
cabinet assembly.
Lower Foot
Rail Brackets
Upper Foot
Rail Brackets
12. Check for leaks. See Checking for Leaks in your owner's manual.
13. Hang table door panel from slots in burner support plate to cover
inside of heater.
Top Assembly
Fasten with
Screw (A)
Pillar
www.desatech.com
3
Publicidad
