Switching On And Off; Chain Brake - Greencut GS200L Manual De Instrucciones

64

SWITCHING ON AND OFF

ATTENTION: Before starting the operation, you must install the battery in the machine.
1. Pull the lever of the front guard/chain brake strongly towards the front handle.
2. Push the trigger release button with your thumb.
3. Pull the throttle trigger. Once the throttle trigger has been depressed, the trigger release is fixed, so you
can release it.
4. To switch off the chainsaw, release the on/off switch.

CHAIN BRAKE

The recoil occurs if the upper edge or the tip of the sword hits the wood or other hard objects. The device is thrown
back and forth with force, which can cause extremely serious injuries.
In order to reduce the risk of injury in the event of a kickback, the device is equipped with a chain brake that is
automatically activated at the moment of impact and will immediately stop the saw chain.
ATTENTION: Before starting to work with this device, the correct functioning of the chain brake
must be checked. If the chain brake does not work properly, contact a service technician immediately.
1. Place the device on the floor.
2. Turn the device on.
3. Tilt the front protector forward. The chain must stop immediately.
11
12