Important - Craftmade Wyman WC42-1 light Guia De Instalacion

9. Light Kit Assembly (Optional). (cont.)
To attach light kit fitter to motor assembly,
align holes in switch housing cap with holes
in switch housing. (NOTE: Make sure to align
gap on edge of switch housing cap with
reverse switch on switch housing for the
correct fit.) Re-insert 3 screws that were
previously removed and use a Phillips
screwdriver to secure all screws.
Install 2 candelabra base 60 watt max.
bulbs (included).
IMPORTANT: When you need to replace
bulbs, please allow bulbs and glass shade
to cool down before touching them.
Place rubber washer (that was previously
removed) inside glass shade over center
hole. Raise glass shade in order to guide
pull chains through corresponding holes
in glass shade. (Be sure pull chain for fan
operation will not rub against bulbs during
fan operation.) Align hole in center of
glass shade with threaded rod on light kit
fitter and push up gently until threaded
rod comes through hole. Replace hex nut
on threaded rod. Tighten hex nut but DO
NOT OVERTIGHTEN hex nut as glass may
crack or break.
Align hole in center of finial plate with
threaded rod, allowing pull chains to come
through corresponding holes in finial plate,
and push up. Thread center pull chain
through hole in finial. Screw finial onto
threaded rod to secure glass shade to light
kit fitter. DO NOT overtighten finial as glass
may crack or break.
Please proceed to Section 10 on page 9 to
complete installation with the light kit.
If you wish to use your fan WITHOUT the
light kit, remove hex nut and lock washer
from threaded rod at top of light kit fitter.
Unscrew switch housing cap to separate it
from the light kit fitter. Then, gently feed
BLACK and WHITE wires from light kit fitter
(one at a time) through hole in middle of
switch housing cap in order to completely
remove switch housing cap from light kit
fitter.
["Light Kit Assembly" section continued
on next page.]
motor housing
switch
housing
light
kit fitter
glass shade
threaded
rod
hex nut
lock washer
light kit
fitter
page 8
rubber washer
hex nut
finial plate
finial
WHITE
BLACK
switch housing
cap
reverse
switch
bulb
motor
housing
light kit fitter