How To Use - HoMedics Mirra WFL-510 Manual Del Usuario

HOW TO USE

Instructions
1. Familiarize yourself with the pump. The switch located at the
front of the pump controls the pump speed. The speed is
indicated by a plus (+) and minus (–) sign. To increase the
speed, move the switch slowly to the left in the direction of
the plus sign. At its highest speed level, the switch will cease
to move any farther. To decrease the pump speed for less
water flow, move the switch to the right toward the minus
sign. Similarly, at its lowest speed, the switch will cease to
move any farther.
2. Connect the male and female parts of the LED light
connector and twist cap tightly.
3. Insert the tube into the pump.
4. Keep the water filled to the suggested level at all times for
optimum performance.
5. Set the fountain top onto the base.
6. Rinse rocks with water. Arrange the rocks on the platform.
7. Attach the AC adapter jack to the base power cord.
DO NOT plug into an outlet at this time.
8. Set the fountain on a level, waterproof surface. To help the
water flow evenly over the entire surface, wipe water over
the entire fountain top with your hand before plugging in.
9. Plug the cord into a 120V household outlet. The switch
located on the power cord controls the fountain. If the
pump doesn't operate, click the power button once to turn
the fountain on and again to turn it off.
NOTE: Ensure that the electrical cord loops below the
electrical outlet to form a "drip loop." This will prevent water
from running down the cord into the electrical outlet.
10. For best results, please operate with the pump completely
submerged. Keep the water level at the fill line at all times.
TO CLEAN
1. To clean the pump: Unplug from electrical outlet. Use a
small brush or stream of water to remove any debris.
2. To keep the water clean: Periodically change the water
and clean the product according to the water condition.
Over time, fountain water and the fountain itself become
dirty. We suggest cleaning and exchanging water weekly
to increase the longevity of the fountain.
3. To clean off hard water deposits on the base: Soak the base
in a mixture of vinegar and water to clean and remove any
mineral buildup.
4. Keep water at an optimum level: Add water periodically to
keep it at an optimum level and to avoid shortening the life
of the pump. Never let the pump run dry.
5. Fountain storage: Unplug the fountain from the electrical
outlet, empty the water, dry the fountain, and store rocks
and fountain in a cool, dry place.
www.homedics.com US: 1-800-466-3342 CAN: 1-888-225-7378
DRIP LOOP
IB-WFL510