Safety Instructions; Disposal Instructions - Goobay 67226 Manual Del Usario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 5
User manual
EN
Two-Device Antenna Amplifier (DVB-T / DVB-T2 / DVB-C)
1

Safety Instructions

• Read the user manual completely and carefully before use.
The user manual is part of the product and contains important information
for correct use.
• Keep this user manual.
The user manual must be available for uncertainties and passing the
product.
Notes for network separation
In an emergency, after use and during thunderstorms, unplug the two-de-
vice antenna amplifier from the socket directly at the plug housing.
• Disconnect the product from the mains when not in use.
Voltage-free only with pulled plug.
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
• Use product, product parts and accessories only in perfect condition.
• In case of questions, defects, mechanical damage, trouble and other
problems, non-recoverable by the documentation, contact your dealer
or producer.
• Place, install and transport product, product parts and accessories in a
safe way.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against accidental use.
• Avoid stresses such as heat and cold, moisture and direct sunlight
vibration and mechanical pressure.
• Use the product only in dry interior rooms.
• Route the cable safely.
Risk of injury by stumbling and falling.
2
Description and Function
2.1
Product
The product is the ideal amplifier for connecting 2 devices in smaller an-
tenna distribution systems (DVB-T, DVB-T2, UKW, DAB+) or BK networks
/ cable TV (DVB-C).
• deal for signal amplification and level adjustment for long signal paths.
• with integrated 230 V power supply unit
2.2
Scope of delivery
Two-device antenna amplifier 2x 15dB (DVB-T / DVB-T2 / DVB-C),
Coaxial cable, User manual.
2.3
Operating elements and product parts
1 Antenna input ANT
2 Housing
3 Output TV 1
4 Output TV 2
5 Mains connection
6 Coaxial cable
3
Intended Use
We do not permit using the device in other ways like described in chap-
ter „Description and Function" or in the „Safety Instructions". Use the
product only in dry interior rooms. Not attending to these regulations and
safety instructions might cause fatal accidents, injuries, and damages to
persons and property.
4
Preparation
Compare the specifications of all used products.
These must match or be in the specified range.
Check the scope of delivery for completeness and integrity.
5
Mounting and Installing
Make sure that the devices to be connected are disconnected from the
mains.
1.
Connect terminals TV1 (3) and TV2 (4) of the broadband antenna
amplifier to the antenna input of a TV set.
It is also possible to use the amplifier with only one TV set. To do
REV2020-10-12
V1.1 ir
Subject to change without notice.
this, select either connection TV1 or TV2.
2.
Connect the antenna amplifier input ANT (1) to the antenna
socket with the coaxial cable (6).
3.
Plug the broadband antenna amplifier into a 230 V~, 50 Hz socket.
4.
Check that the system is functioning by switching on all the connec-
ted devices.
The broadband antenna amplifier is now ready for operation.
6
Maintenance, Care, Storage and Transport
The product is maintenance-free.
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store cool and dry.
• Store the product out the reach of children and in a dry and dust-protec-
ted ambience when not in use.
• Keep and use the original packaging for transport.
7

Disposal Instructions

7.1
Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can damage the health and pollute the
environment.
As a consumer, you are committed by law to dispose electrical and elec-
tronic devices to the producer, the dealer, or public collecting points at the
end of the devices lifetime for free. Particulars are regulated in national
right. The symbol on the product, in the user manual, or at the packaging
alludes to these terms. With this kind of waste separation, application,
and waste disposal of used devices you achieve an important share to
environmental protection.
WEEE No: 82898622
7.2
Packaging
Packaging can be disposed of free of charge at the suitable collection
points – paper belongs in paper bins, plastics belong in yellow sacks and
glass belongs in used glass bins.
DE4535302615620
- 2 -
8
Symbols used
For indoor use only
Alternating current
Class II equipment
Recycling
by Wentronic GmbH | Pillmannstraße 12
67226
IEC 60417- 5957
IEC 60417- 5032
IEC 60417- 5172
ISO 7001 - PI PF 066
Goobay
®
38112 Braunschweig | Germany

Publicidad

Tabla de contenido
loading

Tabla de contenido