Glacier bay HD67540-1008D2 Guía De Instalación Y Cuidado página 12

Installation (continued)
10
Installing the sensor cable
□
Install the sensor cable (1) to the connection (2) of the
and the pillars (4) on the
tightly connected by firmly pushing together.
□
If it is necessary to remove the timer (O), squeeze the tabs (5 & 6) on
at the same time.
CAUTION: If the connections are made properly, the base of the control valve will flash red for 2 seconds and flash for 3 times, the
timer (O) will work. If the connections are not made properly, the timer (O) will not work.
4
6
timer (O) are aligned to one another to ensure proper installation. Ensure they are
1
3
2
5
timer (O). Ensure the holes (3) on the sensor cable (1)
the sensor cable (1) and
12
timer (O)
O