Operating Steps - Swagway X1 Manual Del Usuario

This User's Manual includes instructions and notes; the operator must read it carefully and follow these
instructions. It is very important for you to know all these rules.

5.1 Operating Steps

Be sure your Swagway is fully charged before riding.
First plug the charger into the charge port, then into the
wall. Charge fully before first use.
Step 1: Press the power switch to turn on the Swagway.
Step 2: Get ready to drive. First, step on one pedal to
trigger the foot-switch. The system will enter
self-balancing mode. T hen step on with your
other foot.
Step 3: Stand upright but relaxed. Do not make any
sudden or jerky movements. Shift your weight
forward or back to control the Swagway.
Step 4: Shift your weight to turn. Putting more weight on your right foot turns left. Putting more weight on your
left foot turns right.
Step 5: Get off. Before you get off, make sure that the Swagway is stopped, then step off one foot at a time.
Please be careful.
If the Swagway doesn't self-balance when you trigger the foot-switch, the warning LED will light. Do
not operate the Swagway. Wait a few minutes and try again. If you are on a slope, move the Swagway
to flat ground. If this continues, please contact technical support. DO NOT OPERATE!
Chapter V Learning to use it
POWER Button
Charging Port